rods»view/124

Status Summary for ROD ID 124

<<Prev | Next>>

Test NameStatusNotesModified
Board Status 1 Failed to write id prom. when testing the dma, "No data in buffer!" error shows. additionally, not able to update the firmware using the VME interface. June 17/2011: One of the VME addresses lines is not working properly (A03), initially suspected to be a VME driver problem but turn out not to be the case. The next step will be do have a similar setup to the one for 123. CG: Lift Pin 13 of U9 (A03), reroute Pin 13 of U9 to Pin 48 of U6 ZG 06/11/14: Pass high rate tests, both bottom and top Replaced components: C399, C1R, C94_V2, C84_V2, C96_V2 12-04-2015
patch panel 1
18-05-2012
nse communication 1
18-05-2012
loop data 1
18-05-2012
V4B temp 1
16-05-2011
V4T temp 1
16-05-2011
I3V proms 1
16-05-2011
I5V proms 1
16-05-2011
connectivity 1
16-05-2011
I3V proms 1
16-05-2011
I5V proms 1
16-05-2011
proms load 1
16-05-2011
U82 1
16-05-2011
U81 1
16-05-2011
U35 1
16-05-2011
U34 1
16-05-2011
U33 1
16-05-2011
U32 1
16-05-2011
U31 1
16-05-2011
I3V initial 1
16-05-2011
I5V_initial 1
16-05-2011
fuses 1
13-05-2011
slink
30-11-1999
dram
30-11-1999
sram
30-11-1999
optical loop
30-11-1999
qpll lock
30-11-1999
ttc connectivity
30-11-1999
test fifo
30-11-1999
ddr reset
30-11-1999
assembly
30-11-1999