rods»view/103

Status Summary for ROD ID 103

<<Prev | Next>>

Test NameStatusNotesModified
Board Status B The upgraded connectivity test shows that all signals connected to pins in Bank4 are open on the Misc (including all lb_address signals, the full reset signal, lb_ack, lb_strobe, lb_select, and lb_irq). -ASC 6/4/08 Misc chip reset pin is always high (negatively asserted, thus an open), this is pin AA13 on the misc chip bga. -AC 6/3/08 Won't accept a new misc or V4 firmware. -AC 5/2/08. Attempted misc re-flow. 1st attempt fixed all but one lb_address line. During second attempt misc chip knocked out of position. Misc needs removing from board and replacing (Alex 9/2/10). ZG2015April29: Dorigo replaced Misc chip. Can program proms but versions are read wrong on V2 and Misc. DDR init, NSE and SRAM tests are OK on top and bottom. Cannot opt sync and no events are ever accepted by V2 also from test fifo. 29-04-2015
fuses 1
05-02-2008
U31 1
05-02-2008
U32 1
05-02-2008
U33 1
05-02-2008
U34 1
05-02-2008
U35 1
05-02-2008
U81 1
05-02-2008
U82 1
05-02-2008
I5V_initial 1
05-02-2008
I3V initial 1
05-02-2008
proms load 1
05-02-2008
I5V proms 1
05-02-2008
I3V proms 1
05-02-2008
V4T temp 1
05-02-2008
V4B temp 1
05-02-2008
connectivity 0
05-02-2008
loop data
05-02-2008
slink
05-02-2008
dram
05-02-2008
nse communication
05-02-2008
sram
05-02-2008
optical loop
05-02-2008
patch panel
05-02-2008
qpll lock
05-02-2008
ttc connectivity
05-02-2008
test fifo 1
05-02-2008
ddr reset
05-02-2008
assembly 0
Misc
05-02-2008